1, often the power switch water heater mixing valve ① Natural gas water heater OEM belongs to the rapid heating type hot water equipment, open the water heater mixing valve, the flow control valve detected the introduction of the river, the wireless transmission data to the laptop motherboard, control the ignition operation, But at this time the tap is discharged cold water, wait a few seconds up and down after heating up the boiling water produced to seep into the shower shower spray. ② When the customer closes the water heater mixing valve, the flow control valve cannot detect the water flow, and then the fire is turned off, and the standby state is entered after a few seconds. ③ The customer opens the water heater mixing valve again, and then drains out a section of cold water, and then drains out the boiling water stored by the heat exchanger before, followed by cold water, and then it is the boiling water after regular heating. Not only that, if the water heater mixing valve is often started and stopped, the boiling water temperature of the natural gas water heater productivity is hot and cold. ---- gas water heater wholesale

2, domestic water pressure instability in all normal use of natural gas wall hanging furnace, when the domestic water pressure is too low, the flow control valve detects that the flow is too low, will automatically reduce the spark specifications to ensure that the temperature is stable. However, if the domestic water pressure is unstable, the flow control valve inspection data signal is often changed, resulting in hot and cold fluctuations in the temperature of the boiling water flow. Solution to the temperature adjustment problem: 1, if it is the home water heater, it is not the thermostat water heater as far as possible hand pull adjustment, generally this kind of household water heater has three rotation twist, the first one on the left side is the tire pressure standard specification adjustment, most people are adjusting this control temperature, clockwise rotation is to increase the pressure, temperature rise. 2, the second middle of the small rotation twist is the summer and winter tire pressure standard adjustment twist, generally adjusted to winter can be. 3, the right one is the working pressure adjustment, slowly adjust the working pressure specifications, it is generally not easy to move it, so this twist is also easy to rust out the problem. But not moving it does not harm the use, unless the work pressure is getting less and less. ---- gas water heater manufacturers